Wet Weather Riding - Iridium Visors

[Gippo]

Found that my iridium visor during rain fogs up and water beads on the outside restricting my vision.

RainX type products would go along way at solving this but I was told that chems in these products eat the Iridium coatings.

Anyone have any tips or am I limited to my clear visor in wet weather?

[SVInfinity]

An old trick is to use just a smear of washing up liquid on the inside and outside.

[FJ Steve]

put a wax on the visor?

DO NOT USE RAINX on it.

[FRK]

Look sideways when riding = The forces of the wind pushes the water droplets away

[Billy]

Look sideways when riding = The forces of the wind pushes the water droplets away

thats what i do. helps if the visor is clean (before the rain) aswell

do you keep the vents open when riding in the rain? i dnt have a problem with my helmet fogging you if i keep the bottom vent open.

[Gangus]

crack your visor open one notch and man up

[thatguy]

I don't have a problem... all my visors fog in the rain. I wear a fog off or crack the visor a tiny bit

[Kasper]

it sounds wierd, but smear toothpaste on the inside of the visor, wait till it's dry, then clean it off with warm water; stops the fogging cos it leaves a coat of some sht on it =)

[filbert]

a smear of cat crap inside and out works a treat.

[Kasper]

a smear of cat crap inside and out works a treat.

that'll smell a treat.......

[drifter]

that'll smell a treat.......

it's a brand

[lit]

+1 for

[Panda]

cement inside and out. you know the rest..

[Fab]

Scratch the crap out of the visor. That way you get used to seeing f* all

[Pete750]

after 15 years riding, with cold temps and rain, the best I found ever is the shoei system. a layer of pvc is added behind, letting a layer of air between it and the visor.
no foam anymore. Happy winter
I think it's possible to adapt the pvc layer to any helmet, even if I never tried.