help with small lathe job

[orazzal]

hey all

im hoping some one can help me, i need a 2 piece nylon bush turned out as pictured below or even if someone knows where to buy one, i have tried repco

any help is appreciated
cheers



dimensions are
ID 12.5mm
OD 24mm
Flange Diameter 30mm
Flange Thickness 5mm
Shaft Total Length 24mm

[Captain Starfish]

If you can get a 100mm length of 30mm nylon rod down to South Lake for an hour one day early next week, I can help. There may be someone else a little closer though.

[Old frt]

Yeah, I'm a bit closer, live in Hillarys and have a workshop in Wangara.

I don't have any nylon but heaps of Acetal or Polypropylene.

What are the bushes for?

[zero]

Sounds like it's covered. This was only close:

Redranger Nolathane for longer life suspension systems - performance handling and suspension products. car shock damper swaybar sway bar anti-sway bush bushes australia australian automotive performance road holding turn-in camber caster toe in vehic

[orazzal]

If you can get a 100mm length of 30mm nylon rod down to South Lake for an hour one day early next week, I can help. There may be someone else a little closer though.

thanx for the offer Captain

I don't have any nylon but heaps of Acetal or Polypropylene.

What are the bushes for?

Which one would be harder?

It's to replace a rubber bush on an exhaust mount as I want to limit the amount of movement of my shortened can without using an exhaust bracket if that makes sense

[Old frt]

Acetal is harder but the existing rubber is there to reduce vibration.

Just to clarify, the two piece bush is actually two identical bushes?

[GsxInShed]

SIMPLE english... old fart

we'es just a youngun"

[Old frt]

Sorry [MENTION=25224]GSX IN SHED[/MENTION], let me explain...

Rattly hot bit at the arse end of motorthingy more noisysome rigidnotferme

Itch to thurownthough, appytohelp pissnotwithstanding but tiddly I po po rightnow so imado it Munday sober as.

Bushes R Us. No Brazilians here mate.

[Captain Starfish]

Oi, [MENTION=28240]Old frt[/MENTION], looks like Jamathi's been at your computer.

[Old frt]

Oi, [MENTION=28240]Old frt[/MENTION], looks like Jamathi's been at your computer.

Time to fess up, we are the same person...

[orazzal]

Acetal is harder but the existing rubber is there to reduce vibration.

Just to clarify, the two piece bush is actually two identical bushes?

sorry if this gets confusing, looking at what i wrote now i should have said: if they are identical then the shaft length would 12mm each, when put together total shaft length is 24mm

but being identicle doesnt matter as long as the total shaft length is 24mm

im not worried too much about vibration at the moment

im hoping that this bush along with a new gasket/collar where the exhaust meets the middle section of pipe will lessen the available moment of the can

[Old frt]

[MENTION=33106]orazzal[/MENTION] I'll knock a couple up for you on Monday.

You can pick them up Bus hours in Wangara or Hillarys anytime.

[orazzal]

[MENTION=33106]orazzal[/MENTION] I'll knock a couple up for you on Monday.

You can pick them up Bus hours in Wangara or Hillarys anytime.

Thanks I'll send u a PM soon