If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
you can build your own for less than $20 of metal.
My mate did it to his stunt bike. But he cut holes in the tail to stick the metal in and soldered the rest.
I think theres a video on stuntlife or picture showing that the 12 bar aint gonna stop u from flipping. LIke the other dude said, its main use is for slow wheelies.
you will need:
2 x lenghts of square holow section about 10mm sq. and 600mm long
1 x lenght of circular hollow section about 10mm rnd. and 300mm long
1 x 2 mm thick steel plate about 80mm x 300mm
2 x 8 mm bolts
2 x exhaust clamps
remove ur tail fairing ..
get two lenghts of square hollow section .. place them against the rear sube frame and decide how long they need to be . towards the front of the frame there sould be a bolt hole already there. mark this place on the bars. remove the bars and drill them thru. bolt the bars to the subframe. now use the exhaust clamps to secure the tail end fo the bars to the frame. making sure there really tight. (its suggested to do it this way so u dont have to drill ur sub frame at all)
weld the circular hollow section between the two bars to close the 'U' shape.
now tip the bike on its end and grind the angle of the ground on to the circular hollow section ...making a flat spot. this is the angle u want weld the flat plate on at.
make the required alterations to ur tail farings and reassemble ...
Comment